- December 20, 2015
- Auto Glass Accessories, Install, Luxury Vehicles
- Posted by Patrick
- Comments Off on Mercedes Rear View Mirror Reattachment Fail
Mercedes Rear View Mirror Reattachment Fail From Previous Auto Glass Shop
This is just a note to self…and everyone else out there. When you have a hard time pulling the plastic case housing from a Mercedes rear view mirror and you see the image below, you might want to choose a different shop next time, Yes, what you see holding together this plastic was both windshield glue and double-sided sticky tape. FYI. If you find a trustworthy shop, stick with them!
.
2008 Ford Flex Windshield Replacement In San Tan Valley
Broken Windshield Accessories Are No Fun- October 14, 2015
- Auto Glass Accessories, Windshield Replacement
- Posted by Patrick
- Comments Off on 2008 Ford Flex Windshield Replacement In San Tan Valley
2008 Ford Flex Windshield Replacement In San Tan Valley If you are lucky enough to come across a Ford flex that either hasn’t been done before, or has been done by someone who knows what they are doing, then good for you! If not, then be prepared to obtain new moldings from the local Ford dealership. The following video is basically explaining how to remove the side moldings so that when you put them back on, they will snap back into place as they should. (Basically, break the top guide peg so that you can slide the molding from the clips.) 
Once the side molding is removed, you’ll notice that the clips remain on the vehicle frame. Twist the clip a quarter turn, then pull the clip. It should release with ease. ![]()
Once the side molding is removed, you’ll notice that the clips remain on the vehicle frame. Twist the clip a quarter turn, then pull the clip. It should release with ease. 
The first thing you need to do when doing a windshield replacement on an older corvette convertible is remove the targa top. This is done with loosening the front two torque bolts, not removing them. They are behind the sun visors. The next step would be to locate the three bolts on each side of the rear, but only removing the center bolt entirely on each side. Push on the front of the top, then lift to release from the rear. 
Next you need to remove [...]
